No subject

[crash3m]

jose
try this 'insmod tulip io=0x220 irq=11' replacing 0x220 and 11 with the
appropriate values. (cat /proc/interrupts and .../ioports to see which
are available, if one is being used by the tulip.o driver than use that
value.)

jose sanchez wrote:

> Hello everyone, this is the first time I write to you.
>
> I'm trying to install a Linksys NC100 network card. I checked the
> hardware list and is supported by Linux. It says to use the "tulip"
> module. But, when I issue the command "insmod tulip" I get the
> following message: "Device or resource busy". I would like to know why
> am I getting this error.
>
> I'm a Linux novice and I don't have much experience with it I will
> appreciate your help.
>
> Thank you.
>
>
> -----------------------------------------------------------------------
> Do You Yahoo!?
> Yahoo! Mail Personal Address - Get email at your own domain with
> Yahoo! Mail.