WD/SMC 8013 NIC

[crash3m at crosswinds.net]

I was using the wd.o module.  I even tryied adding IRQ=10 IO=300 in rc.modules
but it still did not work.  I have resolved the issue by changing the jumpers
for IRQ3 and moving the serial port on IRQ3 to IRQ 4.

Matt

JEFF MCCRIGHT wrote:

> I think you want to use the the wd.o loadable module for this adapter.
> Although it is marketed by SMC, it is manufactured by Western Digital, thus
> the WD8013 designation. I hope this helps.
>
> Thanks,
>
> Jeff McCright
>
> On Mon, 11 Dec 2000 06:31:46 -0600, crash3m at crosswinds.net wrote:
>
> >  Here's the situation.  I have an SMC8013 NIC.  in rc.modules i have the
> >  line for smc80x3 cards uncommented, I have added irq=10 io=0x330 to the
> >  end of the line, I have added ether=10,0x300,0xb000,eth0 to my lilo.conf
> >  file. but Linux still does not recognize my card....using a dos bootdisk
> >  and utils I have verified that the irq, io, and ram address are correct
> >  and the card is working.  Hal Duston and I worked on this for several
> >  hours last night but it has done no good.  Any ideas?
> >
> >  Matt
> >
>
> _______________________________________________________
> Send a cool gift with your E-Card
> http://www.bluemountain.com/giftcenter/